|
|
MLX90121
13.56MHz RFID Transceiver
Start Product Discussion
Subscribe to Product
(includes all related assets)
The MLX90121 is an ISO compliant 13.56MHz RFID transceiver integrated circuit.
The main features include user selectable modulation depth in write mode, whereas single sub-carrier ASK, FSK and PSK modulations are recognized in the read mode.
The receiver is based on a diode envelope detector, followed by an IF filter and amplifier. A logarithmic amplifier is used for single subcarrier ASK detection, ensuring fast and clean data recovery. The limiting output of the log amp is used for FSK and PSK recovery.
The transmitter uses a built in open drain output transistor, which can provide up to 250 miliwatts of RF power to a 50 ohms load with a 5 volts power supply using the recommended matching network. This is suitable for most short to mid range applications. A simplified antenna and matching network can be used, at the expense of a reduced reading range, for example in hand-held reader applications.
The chip is configured with a serial interface. A synchronization signal is available when the majority voting is used.
Digital part contains ASK, FSK (423 / 484kHz)and PSK (847kHz) decoders and a programmable encoder to facilitate data handling with a low cost microcontroller. The encoder can be programmed with 6 different patterns.
The chip can also be used as an analog frontend, in direct mode.
The MLX90121 is available for volume production.
Important note:
(1).Purchase of MLX90121s doesn’t imply any grant of any ISO14443A license. Customers are advised to sign patent licensing agreements with all third parties, especially those companies listed in the introduction of the corresponding standard.
(2) RATP / Innovatron Technology
(3) Conformance with ISO/IEC15693 “long distance mode” (6.6kb/s ASK) and ISO/IEC14443A is limited to a temperature range from O°C to 85°C |
|
Buy At Digi-Key
Buy At Future Electronics
Features and Benefits
- Conforms with ISO/IEC 14443A(1)(3)
- Conforms with ISO/IEC 14443B (2)
- Conforms with ISO/IEC 15693 (3)
- Programmable encoder and decoder for custom protocols
- Low external component count
Assets
|
|